Victron Energy MultiPlus-II 48/3000/35-32 GX48V 3000VA inverter/charger with built-in GX device and 35A charger

Overview

The MultiPlus-II 48/3000/35-32 GX pairs a 48V 3000VA (2400W) inverter/charger with an integrated GX device, so a small storage or backup system needs no separate monitoring unit. It provides 5500W peak, a 35A charger, a 32A transfer switch and 95% maximum efficiency, with 11W zero-load consumption. Wi-Fi, Ethernet, USB, VE.Direct and a BMS-Can port for compatible CAN-bus lithium batteries are on board. ESS certificates including EN 50549-1, VDE-AR-N 4105 and UTE C15-712-1 are published. Weight 20kg.

• 24/3000, 48/3000, 48/4k5, 48/5000 and 48/6k5 models
• Built-in GX device with 2×16 character display
• Wi-Fi, Ethernet, USB, VE.Direct and BMS-Can ports
• VRM remote monitoring without an extra GX device
• EN 50549-1 and VDE-AR-N 4105 certificates published
• One GX device per parallel or three-phase system

How it works

The MultiPlus-II GX is a MultiPlus-II inverter/charger with a GX monitoring device built into the same case. The inverter, charger and transfer switch work as on the standard MultiPlus-II: if the grid or generator fails, the loads on AC-out-1 are switched to battery power within 20ms, while AC-out-2 is supplied only when AC input is present. PowerControl and PowerAssist keep a limited grid or generator supply from being overloaded and use the spare capacity to charge the battery.

The integrated GX device shows battery, inverter and solar charger data on a backlit 2×16 character display, and the same data can be read over Wi-Fi or Ethernet. It manages ESS functions, can start a generator through the programmable relay and sends data to the free VRM portal and app. Victron names on-grid and off-grid energy storage and certain mobile systems as typical applications.

Installation and compatibility

Mount the unit on a solid wall in a dry, ventilated room close to the battery, with at least 10cm free all round; vertical fitting gives the best cooling. The BMS-Can port accepts compatible 500kbps CAN-bus managed batteries, but it is not a VE.Can port, so VE.Can products such as MPPT solar chargers or a Lynx Shunt VE.Can cannot be connected to it. For Victron lithium batteries the manual recommends the Lynx Smart BMS, or a smallBMS wired to the I/O port.

In grid-parallel systems the optional 100A current sensor or an energy meter measures the grid connection, so the unit can maximise self-consumption and limit feed-in. For feed-in, the country grid code is selected in VEConfigure and then password-protected; if the local grid code is not supported, an external certified interface device is needed. Victron publishes certificates such as EN 50549-1, VDE-AR-N 4105, TOR Erzeuger Typ A and C10/11 for these models.

Parallel systems and settings

Up to six identical units can run in parallel, and up to 18 in a three-phase system, but only one GX device may be active per system. When several GX models are combined, the internal link between the GX card and the inverter must be disconnected, so Victron recommends standard MultiPlus-II units with an external GX device for such systems. Configuration uses VEConfigure through an MK3-USB interface or remotely via VRM; firmware updates require the MK3-USB.

Questions and answers