Victron Energy Inverter RS 48/6000 Smart48V 6kVA high-frequency inverter with Bluetooth and VE.Can

Overview

The Inverter RS 48/6000 Smart is the version without solar trackers: a 48V high-frequency inverter that delivers 4800–5300W continuously at 25°C, 4500W at 40°C, 9kW for 3 seconds and 7kW for 4 minutes, with 96.5% efficiency at 1kW and 20W no-load consumption. It weighs 11kg (425×440×125mm). Solar energy can come from separate DC MPPT chargers or from a PV inverter of up to 5000W on its output, which charges the battery at up to 88A. It can be paralleled with Inverter RS Smart Solar units.

• 48V inverter, 4800–5300W continuous at 25°C
• 9kW for 3 seconds, 7kW for 4 minutes
• Smart Solar: two 3kW MPPT trackers, 65–450V
• Up to 12 units in parallel, 4 per phase in three-phase
• Display, Bluetooth, VE.Can and VE.Direct ports
• 11kg, built-in battery monitor

How it works

The Inverter RS is a lightweight high-frequency inverter for 48V batteries. Continuous output rises from 4800W at 46V to 5300W at 52V battery voltage at 25°C, with 4500W at 40°C, 9kW for 3 seconds and 7kW for 4 minutes. It has no AC input and is intended for off-grid systems. A PV inverter of up to 5000W can be connected to its AC output: surplus solar charges the battery, and the Inverter RS raises the output frequency to throttle it once the battery is nearly full.

The Smart Solar version adds a bi-directional DC-DC converter and two independent MPPT trackers of 3kW each, with a 65–450V operating range, 120V start-up voltage and a built-in PV isolator switch for both strings. Total charge current from the internal MPPT and AC-coupled PV is limited to 100A. Victron notes that the PV open-circuit voltage should not exceed eight times the battery float voltage, for example 400V for a 50V battery.

Installation and compatibility

Install the unit upright with 30cm clearance above and below, on a non-flammable surface, away from water and direct sunlight. Victron's minimum battery is 200Ah lead-acid or 50Ah lithium, with a 125A DC fuse on 35mm² cable up to 2m, or 200A on 70mm² up to 5m. Victron lithium batteries are connected through a smallBMS to the 2-wire BMS remote inputs. An internal ground relay bonds neutral to chassis, so a type A RCD can be used on the output, which must never be connected to another AC supply.

Parallel systems and monitoring

Up to 12 units can be paralleled over VE.Can, and three-phase systems take up to four units per phase; Smart and Smart Solar models can be mixed, but not with the Multi RS. All units must share one battery bank and be fused individually on the AC and DC side. Settings are made in VictronConnect over Bluetooth, unit by unit. A GX device such as the Cerbo GX connects only through VE.Can and adds VRM monitoring, DVCC and the VM-3P75CT energy meter; the VE.Direct port serves a GlobalLink 520.

Questions and answers