Victron Energy EasySolar-II 48/6k5/100-50 MPPT 250/100 GX48V 6.5kVA inverter/charger with 100A charger, MPPT 250/100 and built-in GX

Overview

The EasySolar-II 48/6k5/100-50 MPPT 250/100 GX is the most powerful model: 6kW continuous at 25°C, 6.5kW for three hours and 8kW for one hour from a cold start, 11kW peak for one minute, plus a 100A AC charger and a 50A transfer switch. Its SmartSolar MPPT 250/100-Tr handles up to 5800W of PV. Victron recommends a 250–1200Ah battery bank and a 250A fuse. At 40kg and 320×670×270mm, it suits larger off-grid homes and backup systems on 48V.

• MultiPlus-II, SmartSolar MPPT-Tr and GX device in one case
• 250V PV input, 70A or 100A solar charging
• Wi-Fi, Ethernet, BMS-Can and VRM remote monitoring
• Two AC outputs, PowerControl and PowerAssist
• Parallel and three-phase operation possible
• Grid-code certificates published for 3kVA and 5kVA models

How it works

The EasySolar-II GX houses three Victron products wired together at the factory: a MultiPlus-II inverter/charger, a SmartSolar MPPT 250/70-Tr or 250/100-Tr whose DC output runs in parallel with the inverter's battery connection, and a GX device with a 2×16-character display. The GX controls the inverter via VE.Bus and the solar charger via VE.Direct, and the inverter's on/off switch also controls the MPPT. Grid or generator power passes through the transfer switch; if it fails, the unit keeps the loads on AC-out-1 running from battery and PV.

Two topologies are supported. In grid in-line systems all loads sit behind the unit and are backed up. In grid-parallel systems an external 100A current sensor or energy meter measures the grid connection, so the unit can maximise self-consumption and, if required, block feed-in, while only critical loads are on the backed-up output. AC-out-2 is live only with AC input present and is included in the PowerControl and PowerAssist current limit.

Installation and compatibility

Install the unit in a dry, ventilated room as close as possible to the battery, with at least 10cm free all round. Battery cables connect to M8 bolts, PV to M6 bolts and AC to 16mm² screw terminals; the AC input breaker must not exceed the transfer switch rating (32A or 50A).

Victron gives recommended battery capacities and fuse ratings per model. Lithium, lead-acid and other chemistries can be used; CAN-bus managed batteries connect to the BMS-Can port (500kbps, not VE.Can). For grid feed-in the country grid code must be selected and is then password-protected.

Parallel, three-phase and monitoring

Up to six units can run in parallel and three-phase systems of up to 18 units are possible, but only identical models can be combined and only one GX device may be active per system, so Victron recommends MultiPlus-II units with an external GX device for such systems. The GX device provides Wi-Fi, Ethernet, USB and VE.Direct, the VRM portal and app, ESS control, automatic generator start and remote firmware updates. A programmable relay and two general-purpose ports are available.

Questions and answers