Victron Energy BlueSolar PWM-Pro 12/24V-10A10A 12/24V programmable PWM solar charge controller

Overview

The BlueSolar PWM-Pro 12/24V-10A is rated 10A of charge and load current, about 120W of panels on 12V or 240W on 24V when multiplied by nominal battery voltage. Every charging and load parameter can be programmed through the optional Remote Panel or PC software, and an optional sensor adds temperature compensation. It shares the 70×138×37mm, 0.13kg housing and 4mm² terminals of the 5A model.

• 5A, 10A, 20A and 30A at 12/24V, automatic detection
• Fully programmable three-stage charging with equalisation
• Optional Remote Panel and PC software via USB interface cable
• Optional battery temperature sensor for compensated charging
• Load output: manual, light on/off, light plus timer, clock
• Integrated battery monitor function, IP30

How it works

The BlueSolar PWM-Pro charges by pulse width modulation in bulk, absorption and float stages, with a programmable equalisation charge. It works out of the box with default values of 14.4V absorption, 13.8V float and 14.6V equalisation (double for 24V), and detects a 12V or 24V battery automatically. As with any PWM controller, the panels must match the battery: 36-cell for 12V, 72-cell for 24V.

An integrated battery monitor tracks state of charge, displayed on the Remote Panel once the battery capacity has been entered and all loads are connected to the load output. With the optional temperature sensor (SCC940100100) charge voltages are compensated by -30mV/°C on 12V or -60mV/°C on 24V systems.

Programming and monitoring

Settings can be changed in two ways. The BlueSolar Pro Remote Panel (SCC900300000) connects with a standard RJ45 cable of up to 20m and gives a backlit display, warning LED and optional audible alarm. Alternatively the free setup and monitoring software runs on a Windows PC through the PWM-Pro to USB interface cable (SCC940100200), which uses RS485 and can manage more than one controller.

Programmable parameters include battery type (gel, AGM, flooded or user defined), battery capacity, temperature coefficient, absorption, float and equalisation voltages and durations, and load disconnect and reconnect levels. Changes are protected by a password. The panel also shows device information, failure history and supports a factory reset.

Load output

The load output defaults to manual control with the button on the controller and low-voltage disconnect at 11.1V (22.2V), reconnecting at 12.6V (25.2V). Other modes are light on/off from array voltage with a confirmation delay, light on plus timer with separate periods after dusk and before dawn, and time control using the internal clock with one or two on-periods. It is protected against overload and short circuit.

Questions and answers